Winter Chemical Glove PVC 12" Gauntlet Acrylic Lined x 6 Watson Gloves Frost Free

Double layer waterproof gloves watson gloves
Double layer waterproof gloves watson gloves
Double layer waterproof gloves watson gloves
Double layer waterproof gloves watson gloves
WG491
Shipping from October 5th
€149.40 TTC
SELECT YOUR SIZE
  • 7 / S
  • 8 / M
  • 9 / L
  • 10 / XL
  • 11 / 2XL

Tarif dégressif dès 2 pièces 137,45 € · dès 10 122,51 €
 

Satisfied or refunded

 

Secure payment

SUMMARY

Pack of 6 Pairs — Winter Chemical Glove Watson Gloves Frost Free 491

Sold as a pack of 6 pairs in a single size. On a wet post, cold does not come from the air: it travels through everything the hand takes hold of. The PVC coating screens it, and EN 511 rates the hold against contact cold at level 2.

Two successive dips of PVC with a resin finish, a heavy acrylic lining, a textured surface that keeps its grip wet or dry.

The 12" gauntlet cuff covers the forearm. Type A chemical protection. Sizes S to XXL. Stated comfort down to −20 °C / −4 °F*.

* Indicative temperature.

TECHNICAL DESCRIPTION

Pack of 6 Pairs — Winter Chemical Glove PVC 12" Gauntlet Acrylic Lined – Watson Gloves Frost Free 491

PROTECTION Severe Cold
RESISTANCE EN 511: 121
USE Workwear
THERMAL PROTECTION Down to −20 °C / −4 °F*
Coating and lining Double-dipped PVC + heavy acrylic lining

Cold and liquids reach the hand by the very same route

A glove that answers two hazards at once. On the outside, a PVC coating applied in two successive dips, closed with a resin finish: sealed against liquids, and supple enough to work in.

On the inside, a heavy acrylic and cotton lining that holds the air your hand has warmed. The surface is textured across palm and back alike, for sure purchase even when wet. The 12" gauntlet cuff runs up the forearm and closes the gap a wrist leaves open.

⚠️ Packaging — pack of 6 pairs. This item is ordered as a pack of 6 pairs in a single size. The price shown and the basket quantity refer to the complete pack.

Grand-Froid expert's view

On a dock in winter, it is not the degrees that hurt, it is the water left sitting on the skin. Here the liquid runs off instead of soaking through, and EN 511 confirms the hold against contact cold — the kind that travels through whatever you pick up. The thumb seams sit clear of the working area: nothing rubs the hollow of the hand across an eight-hour shift.

What is it designed for?

This glove was built for posts where cold arrives with company — water, grease or chemicals. These are the grounds it was developed on.

  • Petrochemicals — contact with aggressive substances, backed by Type A chemical protection
  • Fisheries and fish handling — hands permanently wet, offshore wind, icy bins to shift
  • Waste management — sorting, collection, skips: the cuff shields the forearm as much as the hand
  • Cold stores and chilled warehousing — contact cold travels through everything you take hold of
  • Industrial washdown and cleaning — jets, tanks, greasy surfaces, the texture keeps the grip
  • Harsh outdoor winters — a Finnish January or a Chicago cold snap, where damp doubles the feel of it

Thermal protection

Two mechanisms work together. The acrylic lining traps air within its thickness, which answers ambient cold. The PVC coating screens the skin from frozen objects: that is contact cold, rated at level 2 under EN 511, and the more underestimated of the two on a handling post. The third figure of the standard further attests water tightness. Over the longest exposures, a thin liner glove added underneath widens the comfort range again.

Technical specifications
  • Double-dipped PVC coating with resin finish — barrier to liquids kept alongside suppleness
  • Heavy acrylic and cotton lining — a volume of air held against the hand
  • Textured finish on palm and back — grip maintained on dry and wet surfaces alike
  • 12" (30.5 cm) gauntlet cuff — extended cover up the forearm, bound hem
  • Offset thumb seams — clear of the gripping area, no rubbing point
  • Classic cut
  • EN 511 — convective cold level 1, contact cold level 2, water penetration resistance attested
  • EN 388:2016 — 3X31: abrasion level 3, cut not rated, tear level 3, puncture level 1
  • EN ISO 374-1:2016 — Type A, codes JKLMNPT: chemical protection across seven test substances
  • ANSI/ISEA 105:2016: abrasion level 5 — contact heat level 3
  • Sizes S to XXL — sold as a pack of 6 pairs, in one size
Composition
  • Outer coating: PVC applied in a double dip, resin finish
  • Lining: heavy acrylic fleece and cotton
  • Cuff: 12" (30.5 cm), gauntlet style, bound hem
Commitments
  • REACH compliance — European regulation on the registration and restriction of chemical substances
  • Proposition 65 compliance — tested for lead and phthalates (DBP, BBP, DEHP, DINP, DIDP, DnHP)
  • Manufacturer declaration of conformity — issued 3 February 2026, binding Watson Gloves on materials, dimensions and workmanship
  • John Watson Ltd, Burnaby, British Columbia — independent Canadian glovemaker since 1918
Size guide

Classic unisex cut. The lining takes up room: take your usual glove size rather than sizing down. Each reference is sold as a pack of 6 pairs in a single size.

SizeNumeric size
S7
M8
L9
XL10
XXL11
Care & Durability
  • Rinse with clean water after exposure — the coating cleans at the surface, with no aggressive product
  • Dry cuff downwards — the lining releases residual damp away from a direct heat source
  • Visual check before every chemical task — a nick or a crack in the coating ends the barrier
  • Coating laid in two passes — two thicknesses of material where abrasion does its work
Return or exchange — 30 days
You have 30 days after receipt to request a return or exchange for this item.

Why choose the Frost Free 491?

Few gloves carry a Type A chemical classification and an EN 511 cold classification at the same time. This one holds both, with a forearm length that shorter models leave out.

Why hands go first:

  • Circulatory response: facing cold, the body narrows the vessels feeding the extremities to protect vital organs — fingers receive less warm blood
  • Conduction through objects: a metal bar, an iced bin, a damp crate draw heat away far faster than air does
  • Effect of damp: wet skin loses heat through evaporation, which lowers the perceived temperature at equal conditions

A thin liner glove worn underneath extends endurance on static posts.

* Indicative temperature. Perceived warmth varies with activity, body type, humidity, wind and the layers worn underneath.

You might also like

Satisfied or
refunded
Delivery charge free
from 1000 € *CEE Only
Secure payment
Our customer service
at your service