Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson

Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
Men's Hi-Vis Work Jacket with CORDURA Shoulders CXS Benson
CA1112011
Shipping within 7 days
€83.90 TTC
Select colors
  • Jaune Fluo/Noir
  • Orange Fluo/Noir
SELECT YOUR SIZE

Tarif dégressif dès 2 pièces 72,99 € · dès 10 63,76 €
 

Satisfied or refunded

 

Secure payment

SUMMARY

The Benson jacket reinforces the shoulder — the point that carries loads and rubs against materials — with a CORDURA panel, a high-tenacity nylon weave built to resist abrasion. Its 5 cm segmented reflective tape follows the bend of the arm and the torso.

  • Zipped chest pocket on the left, flap pocket on the right
  • Detachable ID card holder housed in the right pocket
  • Pencil pocket on the left sleeve, zipped side pockets
  • Cuffs adjustable with a touch fastener
  • Covered centre-front zip, closed with touch fastening and press studs
  • Sateen 60% cotton / 40% polyester, 280 g/m²

Meets EN ISO 20471, class 2 — and class 3 when worn with the Benson trousers.

TECHNICAL DESCRIPTION

Men's Hi-Vis Work Jacket Benson — CXS

Use Site & highways
Fabric Sateen 280 g/m²
Safety EN ISO 20471 class 2
Compatibility Class 3 as a set
CORDURA reinforcement Abrasion resistant

CORDURA-reinforced shoulders and 5 cm segmented reflective tape

The Benson jacket puts its technical material where the garment works hardest. The shoulders take a CORDURA panel, at the point that carries loads and rubs against materials. Visibility runs through 5 cm segmented reflective tape, cut so that it follows the bend of the arm and the torso. The rest organises the working day: a zipped chest pocket on the left, a flap pocket on the right with a detachable ID card holder, a pencil pocket on the left sleeve, zipped side pockets and cuffs adjustable with a touch fastener.

The Grand-Froid expert's view

A visibility class is not read on the garment alone, but on the complete outfit. This jacket is rated class 2 worn on its own; paired with the Benson trousers, the set is rated class 3, the highest level of the standard. That is what counts when a risk assessment calls for class 3: the answer is not a brighter jacket, it is hi-vis trousers or bib overalls.

Men's hi-vis work jacket Benson CXS with CORDURA-reinforced shoulders
What is it for?

This jacket suits roles where high visibility is required and where the arms work all day long.

  • Construction and civil engineering: carrying timber, pipe and materials on the shoulder, where the CORDURA takes the rubbing
  • Highways and road works: work close to live traffic, where visibility is required from the start of the shift to the end
  • Maintenance and repair: repeated technical movements, arms in motion, where the segmented tape keeps its flexibility
  • Logistics: moving around the yard, loading and unloading
  • Airside and port areas: aprons, quays and freight zones with permanent hi-vis requirements and an accessible ID holder

Visibility and reinforcement

Reflective tape does not light up: it returns the light it receives back towards its source, whether that is a pair of headlights or a head torch. So it only works while it stays clean and readable. Here the tape is segmented at a width of 5 cm: the segmenting lets it follow the bend of the elbow and the torso without creasing, and stay readable while you move. The fluorescent fabric does the other half of the work, by day and in poor light, when there is no source to light the tape. On the wear side, CORDURA is a high-tenacity nylon weave: it takes abrasion far better than ordinary workwear fabric, which is why it sits at the shoulders rather than across the whole garment. The jacket meets EN ISO 20471 at class 2; worn with the Benson trousers, the set reaches class 3. The class required on a given site depends on the employer's risk assessment.

Technical features
  • CORDURA-reinforced shoulders
  • Segmented reflective tape, 5 cm wide
  • Fluorescent fabric with contrast panels
  • Covered centre-front zip, closed with touch fastening and press studs
  • Cuffs adjustable with a touch fastener
  • Pockets: zipped left chest pocket, flapped right chest pocket, pencil pocket on the left sleeve, zipped side pockets
  • Detachable ID card holder housed in the right chest pocket
  • Fabric weight 280 g/m²
  • Meets EN ISO 20471, class 2 — class 3 as a set with the Benson trousers
  • Meets EN ISO 13688 — category II personal protective equipment
Composition
  • Main fabric sateen 60% cotton / 40% polyester, 280 g/m²
  • Panels twill 60% cotton / 40% polyester
  • Shoulder reinforcement CORDURA
Size guide

Take your usual size, or the next size up if you plan to wear a fleece underneath in winter. The measurements below are those of the jacket laid flat, not body measurements.

Size EU / DE 46 48 50 52 54 56 58 60 62 64 66 68
GARMENT LENGTH 72 73 74 75 76 77 78 79 80 80 81 81
GARMENT WIDTH 57 59 61 63 65 67 69 71 73 75 77 79
SLEEVE LENGTH 63 64 65 66 67 68 69 70 71 71 72 72

Measurements in cm, taken flat. Manufacturing tolerance ± 5%. Cotton products may shrink further after washing.

The length and the sleeves grow by one centimetre per size, the width by two. So it is the width that decides your size — and that is the row to look at if you plan to wear a fleece underneath.

Care & Durability
  • Wash regularly: on a hi-vis garment, cleanliness is part of the protection — tape covered in dust or grease no longer returns light
  • Wash inside out, at low temperature: this garment contains cotton, which shrinks with heat
  • Remove the ID card holder and empty the pockets before washing
  • Close the zips and touch fasteners: left open, they catch the fabric and pull out fibres
  • Use no fabric softener and no bleach: both attack the reflective surface and the fluorescent colour
  • Do not iron the reflective tape — the heat of the iron lifts it off its backing
  • Check the tape and the strength of the fluorescent colour: on a safety garment, these are what signal replacement, ahead of any wear to the fabric
Returns or exchange — 30 days
You have 30 days from delivery to request a return or an exchange on this item.

Why choose the Benson hi-vis jacket?

Because it puts the reinforcement at the shoulder, where a site garment wears through first, and keeps the rest soft. The segmented tape follows the movement, the ID card holder detaches without opening the jacket, and pairing it with the Benson trousers takes the outfit up to class 3.

Dressing for cold weather, from the inside out:

  • Under the jacket: a long thermal top. This is what captures body heat and moves sweat outwards.
  • Then a fleece or a thermal sweatshirt, which holds the warm air. The Benson jacket is unlined, so this is the layer that provides the insulation.
  • The Benson jacket: it handles durability, visibility and storage.

Technical sheets and declarations of conformity

SPÉCIFICATIONS DU PRODUIT ET FICHE TECHNIQUE 1112011 Download (83.27k)


Déclaration de conformité (EU) Veste de travail Canis 1112011 Download (83.27k)


You might also like

Satisfied or
refunded
Delivery charge free
from 1000 € *CEE Only
Secure payment
Our customer service
at your service